Electrifying a Push Scooter With Just a Power Drill
The author retrofitted a Razor A5 Lux push scooter with a Hercules cordless drill as its motor. Rather than purchase a new electric scooter, they chose to modify their existing one to avoid accumulating unused equipment. The drill transmits power to the front wheel via a keyed shaft and one-way bearings, letting the wheel spin freely when the motor is off. Top speed reaches roughly 10 mph with the builder aboard, though the drill runs on lower speed settings due to excessive torque and noise.
Throttle control uses the drill’s relocated trigger on the handlebars, but its sensitivity creates harsh acceleration—most riders give the scooter an initial push before switching to motor power. A 5Ah battery delivers about 2 miles of continuous riding range. The project involved custom machining and 3D printing, producing a two-piece wheel in ASA plastic with a TPU tire bonded via bolted spokes and keyed joints. The final build cost roughly matched a commercial electric scooter purchase, making this a passion project driven by engineering curiosity rather than savings.
Read the full article
Continue reading at Hacker News →This is an AI-generated summary. Read the original for the full story.